地址：廣州市番禺區石基鎮富怡路傍江東村段439-4號
手機：13928804016（胡工） 13427689308（程工）
專注于直流伺服電機,行星減速器,直流無刷電機的生產和銷售!
備案：粵ICP備15022410號-2 SEO：18網絡 技術支持：九鑫傳媒
- 1
- 2
- 3
- 4
- 5
廣州市德馬克電機有限公司
地址：廣州市番禺區石基鎮富怡路傍江東村段439-4號
手機：13427689308（程工）
微信：13828402501（楊工）
手機：13928804016（胡工）
有關電機電壓，功率，轉速，編碼器更換，配減速箱等性能問題，或電機定制開發，驅動器定制開發，請來電咨詢13427689370陳工（微信同號）
SQT91139-48V80A
Lower voltage High temperature resistant hall-less induction driver pecification
一、功能特點Feature：
● 無感控制Sensorless control
● 過壓欠壓保護、過流保護、過熱保護 Protection beyond the scope of power supply voltage\
overload protection\over-temperature protection.
● 報警Various alarm instructions
● 外部電位器調速speed regulation by External potentiometer
● 外部模擬信號調速speed regulation by External analog signal
● PWM控制調速speed regulation by PWM signal
● 報警后自動復位、重啟Automatic reset and restart after alarm
二、技術參數Technical specification
Project | Min value | Typical value | Max value | Unit |
Input voltage | 8 | 48 | 60 | V |
Output current | -- | 50 | 80 | A |
Speed control | 300 | 3000 | 4000 | Rpm |
Size | 154*105*45MM | |||
Ambient temperature | -20 | 90 | ℃ | |
Speed control mode | 1: 0-5VDC analog input 2: 0-100% duty cycle PWM input (PWM Frequency domain: [1Kz-20KHz) 3: External potentiometer speed control | |||
二、端口描述Port definitions：
Port definitions | Specification | |
VCC | Power connection | Power supply positive electrode(8v-60v) |
GND | Power supply negative electrode | |
U | Motor connection | Motor line U phase |
V | Motor line V phase | |
W | Motor line W phase | |
VDD | control single | The positive pole of potentiometer |
VS | Speed regulation signal input | |
COM | The negative pole of potentiometer | |
EN | Speed feedback signal output | |
RVS | Potentiometer,reserve(Apply to function extensions) | |
FG | Output single | Work enable input, connect COM port to work |
ALM | Alarm signal output | |
Red light | indicator light | Alarm indicator，synchronized with ALM signal |
Green light | Power on indicator | |
三、調速說明：Speed regulation description:
Mode 1：Add 0V-5V analog signal to port VS for speed regulation
Mode 2：Add 0%-100% duty cycle PWM signal to port VS for speed regulation,PWM Frequency domain: 1Kz-20KHz
Mode 3：Add potentiometer to port VDD VS COM for speed regulation,10K is recommended for potentiometer.
四、速度反饋說明：
Port FG is Speed signal feedback,
For 8-pole motors, FG frequency * 30 = current speed.
For 4-pole motors, FG frequency * 60 = current speed.
五、保護及報警Protection and alarm
1、堵轉保護、缺相保護，電機被卡死堵轉或電機線斷開一路則停機報警，紅燈快速連續閃爍；
1. Locked rotor protection, motor disconnection protection, if the motor is stuck or the motor line is disconnected, the motor will stop and give an alarm, and the red light will flash quickly and continuously;
2、過流保護，當工作電流大于設定電流則停機報警，紅燈每間隔1秒閃1下；調速信號歸零后恢復。
2. Overload protection: when the working current is greater than the set current, stop the motor and give an alarm, and the red light flashes once every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
3、過熱保護，當電路板溫度大于設定溫度則停機報警，紅燈每間隔1秒閃2下；調速信號歸零后恢復。
3. Over temperature protection: when the temperature of the circuit board is greater than the set temperature, the motor will stop and give an alarm, and the red light will flash twice every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
4、過壓欠壓保護，當供電電壓超出范圍則停機報警，紅燈每間隔1秒閃3下；調速信號歸零后恢復。
4. protection beyond the scope of power supply voltage，when the power supply voltage exceeds the range, the motor will stop and give an alarm, and the red light will flash 3 times every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
四、裝配孔位圖Assembled drawing：
Top view of assembly drawing：
Unit：mm 16 mounting holes, diameter: 3.1mm
五、外部防護Shell and joint description：
1.鋁合金散熱型外殼Aluminum alloy heat dissipation shell
2.格蘭頭防水端子Waterproof connection port
3.驅動器電機聯接端口Drive controller connection port
